CONNECTING THE ANTENNA SWITCH BOX

An antenna switch box is provided as a convenience to allow you to select by the flick of a switch either the ColecoVision TM games or regular TV viewing. Once installed it need not be removed.

FOR FLAT "TWIN LEAD" ANTENNA WIRE USE

Connect the ANTENNA SWITCH BOX as follows:

: Disconnect the flat twin-lead VHF antenna leads from your TV set. Connect the flat twin-lead from the switch box to terminals on the back of the TV set marked "VHF".
: Connect the flat twin-lead (300 OHM) TV antenna leads wich you have just disconnected from the outdoor antenna, cable TV, or rabbit ears to the switch box marked "Antenna". See FLAT "TWIN LEAD" illustration below.

FOR ROUND "COAX" ANTENNA OR CABLE TV USE

NOTE: If you have cable TV or your TV has a round coax cable connector only; a "75 OHM to 300 OHM Balun" matching transformer may be required. This is readily available at a television service department to permit proper connection to the switch box. Connect this balun to the switch box. See ROUND "COAX" illustration below.

go to next page...

page 3