CONNECTING ANTENNA SWITCH BOX TO A T.V. WITH VHF COAX CABLE CONNECTOR ONLY

FOR OUTDOOR ANTENNA

1. Disconnect the internal VHF antenna plug from your T.V. set as shown. Connect the flat twin-lead from the Antenna Switch Box to Screw Terminals on your "300 OHM to 75 OHM Balun". This "Balun" is normally supplied with your T.V. set or is readily available at a local television deal or T.V. Service Department.

   Simply plug the "Balun" on to the VHF antenna terminal on your T.V. set, see illustration below.

2. Connect the flat-lead (300 OHM) T.V. antenna leads from the outdoor antenna to Switch Box Screw Terminals marked "Antenna".

   

   FOR CABLE T.V.

   If you have Cable T.V. repeate step 1 to connect your "300 OHM to 75 OHM Balun" to Antenna Switch Box. Now connect existing round VHF coax antenna or antenna system wire through a coax Balun to the Switch Box Screw Terminals marked "Antenna". See illustration below.

3. Once Antenna Switch Box is installed, it does not need to be removed. Move the switch back to "T.V." for regular viewing.